11/
PRESSURE ADJUSTMENT & CUTTING
TEST
1
2
4
3
–
– Press twice on "Func", s
– Press on « Test »:
Press "On Line" so that the screen shows :
o that the screen shows:
Press on the keys + & - to raise / reduce the pressure.
Start with a low pressure (+/- 70) not to be likely to
transpierce the vinyl.
the plotter cut a rectangle.
– Press "Enter", the screen shows:
5
6
7
–
–
– Once the setting finished, press « Enter » to validate, then press "On line" to launch
cutting.
Press on the key
to advance a little bit the vinyl to be able to check that the
cutting test can be peeled correctly.
If the test is not conclusive, define a new point of origin, then press on Mode to
increase/to reduce the pressure according to the cases. Press again on Test to carry out a
new test.
Repeat these stages till you obtain a satisfactory cutting.
q
12
PROMACUT PC-730E
[email protected] - www.promattex-international.com
Address: 7 bis impasse Denis Dulac, 94700 MAISONS-ALFORT, FRANCE
Phone: 00 33 141 79 00 45 - Fax : 00 33 143 53 93 57
