Operating Instructions
Getting Started
Remove the battery cover (11) from the back of the remote. Insert 2
– AAA 1.5 volt batteries (not included) into
the remote. Be sure to install the batteries in the correct direction following the diagram inside of the battery
compartment.
Connect the power cord to the Power Jack (3). Plug the power cord into any 110v/220v power outlet.
Operation Without Remote
-
Be sure that the power switch on the remote control (13) is in the off position (switch is up).
-
Turn on the master power switch (1) of the light.
-
Adjust the intensity of the light by rotating the Light Intensity Knob (4) until you reach the desired light
output. Note that the LED Display (5) will indicate the relative output of the light from 0.0 to 9.9.
Remote Operation
-
Be sure that the power switch on the remote control (13) is in the on position (switch is down).
-
Turn on the master power switch (1) of the light.
-
Each remote can control up to 100 different lights. Before you begin remote operation you must be
sure that the remote and the light you wish to control are set to the same channel. To set the channel
on the light, press the Channel Selector Knob (4) on the light. The LED will blink. Rotate the knob to
select your desired channel on the display of 00 to 99. After 2 seconds, the LED will blink and return to
the light output display. Set the channel on the remote to the same channel as the light by pressing the
Channel Selector Knob (9) on the remote. The LED will blink. Rotate the knob to the channel of the
light you wish to control. After 2 seconds, the LED will blink and then return to the light output display.
-
In the remote mode, you can select the desired output of the light by rotating the Light Intensity Knob
(9) of the remote until you reach the desired light output. Note that the LED Display (10) will indicate
the relative output of the light from 0.0 to 9.9. As you rotate the knob, the Remote Transmit Light (6) will
blink and the light will beep to confirm that it has received the instruction.
-
As long as the Master Power Switch (1) is on, you may turn the light on with the On Button (7) or off
using the Off Button (8) on the remote control.
Accessories
Your light is shipped with a 7” reflector, cloth diffuser, and 3200°K filter. The accessory mount of the light is a
standard ProMaster/Bowens compatible mount and can be used with soft boxes, umbrellas, and other light
modifying devices. The included diffuser and filter are designed to be mounted on to the reflector. Do not
attach these directly to the light itself.
Important Notes
-
The light output display is not finely calibrated to an actual output in lumens but is intended as a guide
in order to balance the output of multiple lights and to allow for duplicating lighting conditions after the
lights have been powered off.
-
If your lights will not be used for an extended period, be sure to power them off using the master power
switch. When the power switch is on, the lights remain in a stand-by state and still consume a small
amount of electricity.
-
If you will not be using your remote for an extended period of time, be sure the remote power switch is
off. Remove and store the batteries separately to avoid damage to your remote.
