Promaker PRO-ES2009, User Manual

Page: 13 / 32

13
over a prolonged period. Therefore
you should not try to accelerate
your working speed by increasing
pressure on your machine. The
abrasive disks work more efficiently
if only slight pressure is exerted on
the grinding machine, thus avoiding
a drop in the grinding speed
Check the delivery parts
Carefully remove the tool from its
packaging and check if the following
parts are complete:
1 x Angle grinder
1 x Side handle
1 x cutting-off protective cover
1 x grinding protective cover
1 x spanner
1 x External flange with thread
1 x Internal flange
7.Maintenance/Cleaning/ Lubrication/
Storage
Maintenance
Always be sure that the tool is
switched off and unplugged before
attempting to perform inspection or
maintenance.
If the carbon brushes need to be
replaced, have this done by a qualified
repair person (always replace the two
brushes at the same time)
If the supply cable is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
Cleaning
The tool and its air vents have to be
kept clean. Regularly clean the tool’s
air vents or whenever the vents start
to become obstructed.
Avoid using solvents when cleaning
plastic parts. Most plastic parts are
susceptible to damage from various
types of commercial solvents and
may be damaged by their use. Use
clean clothes to remove dirt, carbon
dust, etc.
Lubrication
All the bearings in this tool are
lubricated with a sufficient amount
of high grade lubricant for the life
of the unit under normal operating
conditions, therefore no further
lubrication if required.
Storage
Store the angle grinder in a dry
place. Regularly inspect the disks
/ wheels, ensure that the disks /
wheels is free of cracks and surface
defects. Replace the disks / wheels
when it has wore out.
Take care not to expose this tool to
the rain.