Promac 322BE1-BP, Manual

Page: 14 / 24

14
8
1. This machine is designed to allow the
sanding belt to be operated vertically or
horizontally at comfortable choice.
2. Use 6mm hex. Wrench may loosen and tighten
cap screw to adjust frame assembly in proper
angles.
9
Curve Sanding
1. Put frame assembly to horizontal position.
2. Loosen screw A showed in figure.
3. Open the roller cover to proper position and fix it.
4. This machine is now ready for the
operation of curve sanding.
ASSEMBLY CHART-SANDING BELT DEVICE
RELACEMENT OF WHEEL
1. Remove toolrest and eyeshield or dust collector
unit from wheel cover by taking off bolts and
screws.
2. Take off screws to allow removing wheel cover
as figure.
3. Remove nut, sleeve washer or balancing flange
and waste wheel.
4. Put new wheel and very parts back in reverse
order. It's important to make a good adjustment
of balancing before.
5. assembling wheel cover. This message could be
learned.
6. For your safety, check all screws and bolts.
Make sure they are all well fixed before switch
on.
7. The distance between wheel, spark arrestor and
toolrest table should be always remained at
about 5mm to get the better spark arresting
effect and good grinding performance.
8. When this distance was changed due to the
wearing of wheel, you need to do adjustment.