Proluxe DP1100GB, Operation Manual

Page: 11 / 17

DOUGHPRO
DP1100 Trouble Shooting Guide
Symptom Probable Cause Action to be Taken
Heater Platen overheating If the Relay (depending the year of
the model) on the coil side are
receiving 12vdc indicates the
Controller is functioning properly. On
the switching side of the relay, is
there 120 vac going to the heater in
question . If there is no voltage on
the to the switching side of the relay
to the heaters, the Relay is not
working properly Replace Relay If the Controller's heat-
on LED is not lit indicating the
controller is working properly.
Dough not having same thickness
across the press dough. To adjust upper platen for level press Underneath the arm resting on the
Upper Platen Shroud you will find 4,
stacked hex bolts sitting over the upper
platen attach to the arm. The top bolts
are called locking bolts. The 4 larger
Hex Bolts below are Adjustment Bolts.
Break free the 4 Locking blts. With a
open end wrench adjust the A. bolts
(1/8 turn at a time where needed and
test with dough. After satisfied,
tighten the Locking bolts making sure
not to move the larger Adustment
Bolts.