standard 120 volt 15 amp electrical wall outlet. Most people
install the vacuum in the garage, utility closet or far away from
living space (so you cant hear it when it turns on). Make sure
it is installed inside and out of rain and away from moisture.
Do not install the vacuum near a source of extreme heat (i.e.
water heater, furnace etc) or in a area with high temperature.
Exhausting the vacuums air to the outside is recommended for
optimal performance.
Step 4 -Find a wood stud in the wall to screw your wall mount
plate to. Using the mounting plate provided with your vacuum
cleaner, secure the unit to the wall (be careful to never drill
screws where there might be a chance of hitting electrical or
plumbing lines) as shown in figure 1 below. Be sure to
install at a comfortable height that allows you to empty the dirt
basin as needed. Allow at least 28 inches from the bottom on
the dirt basin on the vacuum to your floor to leave enough room
to take off the dirt basin as needed.
How to Clean Filter
The filter is self-cleaning.
However,
if
cleaning is desired,
just follow with below steps:
1. Ensure the power unit is not running before removing
the dust container.
2. Remove the dust container.
3. Tightly wrap a large plastic garbage bag around the
filter of the power unit.(as illustrated in Figure 4
above).
4. While holding bag tightly with one hand, grasp the
filter through the plastic bag with the other hand and
shake the filter. Dust will drop into bag.
5. Carefully remove the plastic bag from the unit.
6.
Replace the dust container on the power unit.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical vacuum appliance, basic
precautions should always be followed, including the
following:
4
9
