- 11 -
HOW TO EMPTY THE DUST CONTAINER
The dust container must be emptied as soon as it reaches the “MAX” mark indicated on the outside of the tank, or if
the suction power has dropped. To empty the Dust Container, please follow the instructions below:
1.
Switch the vacuum cleaner to the “Off” position and disconnect the plug from the wall outlet.
2.
Release the dust container by pressing down the release button. (Fig 10)
3.
Pull the dust container away from the vacuum cleaner.
4.
Hold the dust container low over your trash receptacle, to avoid dust falling onto your floors.
5.
Press the release button. When the release button is pressed, the bottom cover will open and the dust will
drop into your trash receptacle. (Fig 11)
Fig 10
Fig 11
HOW TO CLEAN AND REPLACE THE Vortex & HEPA FILTERS
There are two filters in this unit - the intake Self-Cleaning Vortex filter, and the exhaust HEPA filter. When the
filters are too dirty, and the suction power is reduced, you must clean or replace the filters.
TO CLEAN AND REPLACE THE VORTEX INLET PRE-MOTOR FILTER:
1.
Open the top Vortex chamber cover by rotating the cover counterclockwise. (Fig 12)
2.
Pull the Self-Cleaning Vortex filter from the chamber by rotating it counterclockwise to unlock it, and then
pull it up and out of the unit. (Fig 12)
3.
Clean the filter using warm water, then allow the filter to air dry completely. Once the filter has completely
air dried, then place the filter back into the Vortex chamber. Or, if the filter is too dirty, or in an unusable
condition, replace the filter with a new one.
