7
Lamp
Lamp cover
Power Failure
If there is a power failure for a short time less than 11 hrs keep the door closed
Frozen food should not be affected if the failure lasts for more than 11 hrs.
Extra protection can be given by covering the appliance with two or three thick blankets.
If a long power failure is anticipated, try to get the foodstuff into another appliance or
cold store, if possible.
If the power cut is longer than 11 hrs then check the content of the freezer.
If the food has defrosted, cook and refreeze the food or it should be eaten immediately.
Never refreeze food that
h
as been defrosted.
Disconnect the appliance from the mains supply.
Pull the lamp cover forwards, to gain accesses to the lamp holder. Unscrew the light
bulb in an anti clockwise direction from the holder.
Replace the bulb with one of the correct type and size (10 watt SES E14 base).
Replace the cover by Pushing the cover Backwards along the grooves.
Reconnect the appliance to the mains supply.
Changing the light bulb
Note.
Light bulbs are not covered by the warranty
If the appliance is not to be used for a long period of time then it is recommended to
remove all the food stuff, clean the inside of the appliance and leave the door open to
allow the air to circulate thus avoiding unpleasant odors.
Cleaning and maintenance
Before any cleaning or maintenance is carried out you must disconnect the appliance
from the mains supply by removing the plug, never remove the plug by pulling on the
mains cord. Remove the plug by pulling on the plug itself.
It is recommended that when cleaning the appliance, both the inside and outside, can be
cleaned using warm water and a little bicarbonate of soda. Use 1 teaspoon to 1.2 litres
of water.
Warning: The refrigerating system must not be damaged at any time.
This Freezer is frost-free and does not need defrosting.
Freezer defrost process
Refrigerator defrost process
The refrigerator defrosting process is carried out automatically every time the
compressor stops.
The defrost water drains from the cabinet into a tray placed on the top of the
compressor to the rear of the unit where it evaporates.
