Proline PCH460T-E, Operating And Installation Instructions

Page: 11 / 144

Downloaded from www.vandenborre.be
Turning the appliance on / off . .
If the appliance is in Stand-By-Mode, it is put in Operating-Mode by pressing
the On/Off button at least 1 second. A beep indicates a successful
operation.
On all heaters a ´0` appears and all Decimal Point of the heater flashes.
If there is no operation within 10 sec, the display of all heaters will turn off.
If the di spla ys are turned off, the hea ter wil l b e s et to off.
If is pressed more than 2 sec (in Operating-Mode ), the appliance is
switched off and is set into the off mode again. The appliance can be turned
off by pressing at any time; even if other buttons are pressed
simultaneously.
.............................................................................
If there is residual heat remaining, this will be indicated by a flashing H in
the corresponding
Heater Display .
Select Heater .
If a single heater is chosen with the corresponding Active/Deactive Heater
Button , the Decimal Point of the related Heater Display flashes. For the
selected heater, you can set the heat level between 1-9 by touching the
Heat Setting Buttons or . .
The buttons must be pressed within 3 sec, otherwise the heater selection
is erased and heat setting dot will disappear (
Decimal Point ). If there is no
further operation within 10 sec, the heater falls back into off mode.
The heat setting can always be changed by pressing or between
level 1-9.
.
Each button operation or each display change is accompanied by a beep.
8