Proline DWI 5212P, Instruction Manual

Page: 11 / 12

.10.
Installation
GB
Positioning the Appliance
Position the appliance in the desired location. The back should
rest against the wall behind it, and the sides, along the adjacent
cabinets or wall. The dishwasher is equipped with water supply
and drain hoses that can be positioned to the right or the left to
facilitate proper installation.
Levelling the Appliance
Once the appliance is positioned, adjust the feet (screw them in
or out) to adjust the dishwasher, making it level. In any case, the
appliance should not be inclined more than 2˚. If the appliance is
level, it will help ensure proper performance.
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(gas)
connector, inserting the small filter supplied with the dishwasher
and making sure that it is fastened tightly in place (see Fig.1).
If the water pipes are new or have not been used for an extended
period of time, let the water run to make sure that the water is
clear and free of impurities. If this precaution is not taken, there
is a risk that the water inlet can get blocked and damage the
appliance.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter
of 4cm, or let it run into the sink, making sure to avoid bending
or crimping it. Use the special plastic support that comes with
the appliance (see Fig.2). The free end of the hose must be at a
height between 40 and 100 cm and must not be immersed in
water.
Attention:
The special plastic hose support must be solidly fastened to the
wall to prevent the drain hose from moving and allowing water to
spill outside the drain.
ELECTRICAL CONNECTION (UK ONLY)
For your safety please read the following information.
Caution:
The dishwasher plug must be accessible even when the appliance is
installed as a built-in unit so that maintence can be done safety.
Fig.2
Warning: This appliance must be earthed.
Fig.1
The appliance must be connected to a 220-240 volts 50 cycle
AC supply by means of a three pin socket, suitably earthed and
should be protected by a 13 amp fuse in the plug or a15 amp
fuse in the consumer unit.
The appliance is supplied with a moulded 13 amp 3 pin mains
plug fitted with a 13 amp fuse. Should the fuse require
replacement, it must be replaced with a fuse rated at 13 amp
and approved to BS1362.
The plug contains a removable fuse cover that must be refitted
when the fuse is replaced. In the event of the fuse cover being
lost or damaged, the plug must not be used until a replacement
cover has been obtained.
If the moulded mains plug is unsuitable for the socket outlet in
your home or is removed for any other reason, then the fuse
should be removed and the cut off plug disposed of safely to
prevent the hazard of electric shock.
There is a danger of electric shock if the cut off plug is inserted
into any 13 amp socket outlet.
How to wire a 13 amp plug.
Important
The wires in the mains lead on this appliance are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue – Neutral
Brown – Live
As the colours may not correspond with the markings identifying
the terminals in your plug proceed as follows.
The green and yellow wire must be connected to the terminal in
the plug which is marked with the letter E or with the earth sym-
bol or coloured green and yellow.
The blue wire must be connected to the terminal marked N or
coloured black.
The brown wire must be connected to the terminal marked L or
coloured red.