NOTE: In the event of a power failure
Once the power is restored after a power failure, the appliance will continue to operate at the selected
settings before the power failure.
If the appliance has been switched off and needs to be switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Mode Selection
GB5
Dehumidifying mode
1. To operate the appliance in the dehumidifying mode, repeatedly press
until no mode indicator
light illuminates.
2. Repeatedly press or press & hold
/
to set the desired humidity level in 5% increments.
The humidity level can be set within a range of 35%RH (Relative Humidity) to 85%RH (Relative
Humidity).
For drier air, set the humidity level for a lower percentage value.
For damper air, set the humidity level for a higher percent value.
3. After you have set the desired humidity level, the display will briefly show the set humidity level and
then return to actual ambient humidity level.
Continuous dehumidifying mode
Repeatedly press
until the indicator light
illuminates, indicating that the appliance is in the
continuous dehumidifying mode.
With this function the appliance will operate continuously.
NOTE:
You cannot set a desired humidity level when the appliance is in this mode.
Dryer mode
Repeatedly press
until the indicator light
illuminates,
indicating that the appliance is in the dryer mode.
The fan speed is fixed at turbo setting and the indicator light
will
illuminate. The humidity level will be automatically controlled
according to the ambient humidity.
This mode will be cancelled after operation for a maximum of 10
hours.
When the clothes are dried, take the clothes down and put them into
closets.
Downloaded from www.vandenborre.be
