9
MAKING CAPPUCCINO
Cappuccino is a popular espresso-based coffee drink. Follow the steps below so that you may have
enough steam pressure to froth and steam milk properly.
1.
Prepare espresso first following steps 1 to 8 in the Making Espresso section above.
2.
Press
/
.
•
The green steam indicator light (
) will flash while the green espresso indicator light
(
) will go out.
3.
Wait until the green steam indicator light stops flashing.
4.
Fill a pitcher (not supplied) with 100ml milk for cappuccino to be prepared and set aside.
•
It is recommended to use whole milk at refrigerator temperature.
•
When you choose the size of the pitcher, bear in mind that the milk volume will increase by 2
times.
5.
Position the pitcher containing the milk on the drip tray.
6.
Insert the frothing device into the milk by about 2cm.
•
Remember that the frothing nozzle is not submerged too deep, but just deep enough to stay
below the surface of the milk and also prevent the milk from splattering around.
7.
Slowly turn the steam control knob anticlockwise. The steam will come out from the frothing
nozzle.
NOTE:
Never turn the steam control knob quickly, as the steam will accumulate rapidly in a
short time, which may increase the potential risk of explosion.
8.
Move the pitcher containing the milk up and down under the frothing device to create the
desired milk froth.
9.
When the milk has sufficient foaming, turn the steam control knob to the Off position by turning
it clockwise until you cannot turn it any further.
10.
Pour the frothed milk into the espresso and the cappuccino is ready. Add sugar to taste.
11.
Press
to turn off the appliance.
•
The red indicator light (
) and the green indicator light (
)
will go out.
12.
If more Cappuccino is required, follow the instructions above, allow
the appliance to cool for at least 5 minutes after each
brewing cycle.
IMPORTANT: Always clean frothing device with a wet sponge immediately after use. Be careful
not to touch the steam wand. Remove the frothing nozzle and check that the steam wand is not
blocked. If necessary use a needle to remove any solid milk.
MAKING HOT WATER OR BEVERAGES
The frothing device can be used to make hot water or beverages like drinking chocolate or tea.
1.
Fill the water tank with the desired amount of water. The water level
should not exceed the MAX 10 line.
2.
Plug in the appliance and press
.
Downloaded from www.vandenborre.be