Power cord rewinding
When not in use, unplug from the power outlet and then press the cord rewind
button to feed back the power cord.
CAUTION
: Take special care to rewind the mains cord by holding the plug to avoid
injury by a whipping action.
Storage
Insert the holder of the floor brush with telescopic tubes into the storage clip at the
back or on the rear of the appliance.
TROUBLESHOOTING
Please check the following details before you have your appliance repaired by an
authorised servicing agent.
Problem
Possible Cause
Possible Solution
Vacuum cleaner
does not work.
1. Check if the power plug is
firmly inserted into the
power outlet.
2. Check if the power button
of the appliance is pressed.
1. Insert the plug back into
the power outlet and
ensure it is switched on.
2. Press the power button
to turn on the vacuum
cleaner.
Suction power
becomes weak.
1. Check if the hose, brush or
tube is clogged or damaged.
2. Check if the dust tank is
full.
3. Check if the filter is
clogged, the tube is correctly
attached.
1. Immediately remove the
obstruction.
2. Empty the dust tank.
3. Clean the filter or
reassemble the tubes.
Power cord will not
fully feedback.
Check if the power cord is
twisted.
Pull out the power cord at
its optimal length and
rewind it.
Power cord cannot
be pulled out.
The power cord may be
twisted.
Rewind or pull the cord in
and out several times by
pressing the cord rewind
button.
SPECIFICATIONS
EG-
8
Ratings:
220V
‐
240V
，
50
‐
60Hz 700 W
Downloaded from www.vandenborre.be
