6
EN
OPERATION
CLEANING AND DESCALING
Before first use, it is recommended to operate the kettle for 2 to 3 times following
the instructions below. This will remove any dust or residues remaining from the
manufacturing process.
Always switch off and unplug the appliance from the mains socket and allow it to cool
down before cleaning.
• Clean the exterior of the kettle and the power base using a damp cloth. Dry thoroughly.
• Clean the interior of the kettle with a soft sponge and warm, soapy water. If you hand
does not fit in the lid opening, swish warm, soapy water around inside the kettle with
the lid closed. Rinse any remaining soapy water from the kettle.
• Remove the mesh filter from the spout. Clean it under running water and then
replace it.
• Do not use any abrasive or chemical cleaning agent.
• Never immerse the kettle and the power base in water.
• Regularly descale the kettle using a specific descaler.
1. Place the power base on a dry, flat and stable surface.
2. Open the lid by pressing the lid release button.
3. Fill kettle with desired amount of cold water.
• Always fill the kettle between the minimum and maximum marks on the water
level window.
4. Close the lid by pressing it down.
5. Place the kettle on the power base and insert the plug into the mains socket.
6. Press the power switch. The water is being heated.
• The indicator light on the power switch will illuminate.
7. The kettle will switch off automatically when the water has boiled.
• The indicator light will go out.
• You can stop the boiling process by setting the power switch to the “OFF” position.
8. Lift the kettle from the power base and then slowly pour the boiling water.
NOTE: Use the kettle only when the lid is closed and the filter is in place.
Cut-out for boil-dry protection
If you operate the kettle without water, the kettle will stop heating and automatically
switch off.
If this occurs, allow the kettle to cool before filling with cold water and re-boiling.
Downloaded from www.vandenborre.be