ProLine Range Hoods PLZW KB.30-48, Installation Manual And User'S Manual

Page: 7 / 16

Step 5: Make your electrical and
ducting connections. Use 6” rigid
duct wherever possible. Try and
minimize the use of elbows. More
elbows and longer runs create higher
static pressure. The hood comes
with a grounded three prong plug
that can either be direct wired or
plugged into a 20 amp. circuit. fig. 4
fig. 4
Step 6: Install the 2 part chimneys
on top of the hood by sliding the
inside section up until the vertical
vent slots are visible. Then put
both pieces on top of the hood and
secure the lower portion with the
provided screw at the bottom. fig. 5
Step 7: Slide the upper portion up
and over the top mounting bracket
aligning the holes and securing with
the screws provided. fig. 6
fig. 5
fig. 6
7