ProLights Z8STRIP, User Manual

Page: 32 / 44

Z8STRIP 10
3.5 AUTO SHOW
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MODE so many times until the display shows Auto Show , then press the button ENTER.
• Press the button UP/DOWN to switch between the show Auto 1 - Auto 14 . The unit will operate in show
mode.
• Using the button UP/DOWN to select the desired run speed slow-fast 0-100 .
• Press the button ENTER to save the setting.
IMPORTANT: Programs Auto 1 - Auto 14 are fully pre-programmed and will not be altered by changes.
3.6 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MODE so many times until the display shows Static , then press the button ENTER.
• Select Fixed Color through the buttons UP/DOWN, then press the button ENTER.
• Set the colors R , G , B, W, GB, RB, RG, RGB, RW, GW, BW, RGW, RBW, GBW, RGBW through the buttons UP/DOWN,
then press the button ENTER.
• Press the MODEbutton to go back or to meet the waiting time to exit the setup menu.
3.7 MANUAL MODE
This mode allows to combine the colors red, green blue and white (R, G, B, W) .
• Press the button MODE so many times until the display shows Static , then press the button ENTER.
• Select Manual Color through the buttons UP/DOWN, then press the button ENTER.
• Select the color R, G, B, W through the buttons UP/DOWN, then press the button ENTER.
• Using UP/DOWN button, select the desired color value 000 - 255 .
• Press ENTER button to continue to the next color R, G, B, W .
• Continue until the desired mix is obtained.
• Press the MODE button to go back or to meet the waiting time to exit the setup menu.
3.8 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
• Set on master fixture the desired program (see section 3.5).
• Set the slaves to the same DMX modes.
3.9 LINKING
1. Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.10 DMX MODE
• Press the button MODE so many times until shows 4 Ch, 6 Ch, 10 Ch, 32 Ch or 37 Ch and press the button
ENTER to confirm.