V575SPOT
10
3.8 Changing the operating parameters
The parameters described below can be changed by calling the menu:
1. Press the button MENU (11) so many times until the corresponding menu item is shown on the display.
2. For the first eight menu items (
start address to
display off), confirm the selection with the
button ENTER (13). Then make the adjustment with the button DOWN or UP (12) and memorize it with
the button ENTER within 8 seconds. The operation of the other menu items is described in detail. When
these menu items are selected, the display starts flashing.
3. To go to the next menu item, press the button MENU or select the desired menu item with the buttons
UP and DOWN (12).
4. If no further button is pressed for 8 seconds while a menu item is selected, the menu will disappear.
Pan motion of the pan head:
normal
opposite panning
Tilt motion of the pan head:
normal
opposite movement
LED Display on/off:
display on
display off
After exiting the menu, the address or the operating mode will be displayed for approx. 30 s, then the display is switched
off. As soon as one of the buttons (11 – 13) is pressed, the display will be switched on again.
Display representation:
normal
turned by 180° (for ceiling suspension)
Switch over the adjustment with the button ENTER. The display will flash for 8 seconds. Then the menu will disappear.
Adjustment of the start address:
. . .
16/8-channels DMX mode:
16 channels
8 channels
Show mode:
. . .
show 1
show 4
Slave mode:
. . .
2 light show
normal
Blackout on (yes blackout). If no DMX control signal is
present at the jack DMX INPUT (6), the pan head will go to its
starting position and the shutter is closed. Operation via the
remote control is possible.
Blackout mode:
Blackout off (no blackout). If no DMX control signal is present,
the unit is controlled via the integrated microphone and, if
desired, via the remote control.
