MOBY40
22
3.17 CALIBRATION FUNCTION
Press the button MENU to enter the password confirmation, to enter the correct password
UP+DOWN+UP+DOWN button, press the MENU in the correct password will enter show submenu.
WHITE SETTING
Enter the [
CAL
] mode to select white color of different color temperature;
•
Press the button MENU then press the button UP/DOWN so many times until show [
CAL1
]. Press the
button ENTER to confirm.
•
There are 11 pre-programmed white colors (
WHITE01 - WHITE11
) can be edited by using red, green,
blue, and white (
Red - Green - Blue - Amber
).
•
Set the value (
000 - 255
), through the buttons UP and DOWN.
WHITE BALANCE
Enter the [
CAL2
] mode to adjust the RGB parameter to make different whites.
•
Press the button MENU so many times until show [
CAL2
] and press the button ENTER to confirm.
•
Select red, green blue or white (RED - GREEN -BLUE), through the button UP/DOWN. Press the but-
ton ENTER to confirm.
•
Set the value 000 - 255, through the button UP/DOWN.
•
When the new setting is activated, the DMX controller choose RGB=255, 255, 255 the write color will
be made by actual RGB values on the [
CAL2
].
3.18 OPERATION WITH WIRELESS DMX
•
Connect to DMX Controller, the transmitter will transmit signal to the other connected fixtures (fig.15).
NOTE - Be sure the MOBY40 are Max 300 meters around the transmitter.
•
Power on all units.
•
Enter menu mode of the unit, set wireless control to be available.
- Press the button MENU then press the button UP/DOWN so many times until show
[RUN]
. Press the
button ENTER to confirm.
- Press the buttons UP and DOWN to select
[DMX]
mode.
•
Then enter the
[WDMX]
mode to change WDMX settings.
- Enter the
[ACTI]
menu to turn On/Off WDMX functionality.
- Enter the
[REST]
menu to reset the WDMX pairing.
•
Once a lighting fixture has been paired with a WDMX transmitter, the green signal indicator will display.
Once a lighting fixture has been paired with a WDMX transmitter, the lighting fixture cannot be paired
with another WDMX transmitter. If a lighting fixture requires pairing with a new WDMX transmitter, the
steps must ben repeated.
