LUMIPIX6Q
10
3.4 SHOW MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
•
Press the button MENU so many times until the display shows
[SHOW MODE]
, then press the button EN-
TER.
•
Press the button UP/DOWN to switch between the show (
SHOW 0 - SHOW 12, FADE, FIXT C or MANU C
). The unit
will operate in show mode.
IMPORTANT: Programs
SHOW 0 - SHOW 12
are fully pre-programmed and will not be altered by changes.
Instead,
MANU C
mode allows to combine red
[R]
, green
[G]
, blue
[B]
and white
[W]
.
•
Press the button MENU so many times until the display shows
[MANU C]
, then press the button ENTER.
•
Select the color red, green blue or white (
R - G - B - W
) through the buttons UP/DOWN.
•
Press the button ENTER to confirm.
•
Set the value (
000 - 255
), through the buttons UP/DOWN.
•
Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.5 SOUND MODE SENSITIVITY SETTING
•
To enable the Sound mode, press MENU repeatedly until
[SHOW MODE]
shows on the display.
•
Press ENTER button to confirm.
•
Press UP/DOWN button to choose
[ON]
.
•
Press the button ENTER to save the setting.
Adjust the control SENSITIVITY (9) for the microphone sensitivity so that the dynamic power of the music
will be reproduced in an optimum way by the movements of the light beam and the change of the colours.
The highest sensitivity is set with the control at the right stop.
NOTE - When changing the volume of the music system, the microphone sensitivity must be adapted ac-
cordingly via the rotary control.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
•
Press the button MENU so many times until the display shows
[M & S]
and press the button ENTER.
•
Press UP/DOWN to set the unit as master or slave
(MASTER, SLAVE 1 o SLAVE 2)
.
•
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 12).
3.7 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
