ProLights LUMIPAR6Q, User Manual

Page: 31 / 36

13
LUMIPAR6Q
Fig.7
IR REMOTE
BLACK
OUT
AUTO
STROBE SPEED
SOUND
SENSI-
TIVITY
%
MANUAL
FADE
SNAP
R G B
+
0
1 2 3
4 5 6
7 8 9
LumiParIRC
3.15 OPERATION THROUGH THE IRC CONTROLLER
To control the LUMIPAR6Q with the infrared remote control:
• Press the button MENU repeatedly until [SEr] , then press button ENTER to confirm.
• Using UP/DOWN button to select [ON] or [OFF] to enable or disable the infrared remote control.
• Press the button ENTER to confirm the chose.
NOTE - Make sure to point the controller directly at the receiver on the product.
Auto Mode
Automatic Mode will enable you to run the automatic programs on the product.
To turn on Automatic Mode:
1. Press AUTO on the controller.
2. Press + or – to choose between the different auto programs (P1-P4).
To adjust the speed of the automatic program:
1. Press SPEED to adjust the auto programs speed.
2. Press STROBE to active the auto programs Strobe function, strobe speed can
be adjusted by + or – buttons.
Sound Active Mode
Sound Active Mode will enable the product to respond to the music.
To turn on Sound Active mode:
1. Press SOUND button, the device will run P5, press it again, switch to P6.
2. Press + or – to adjust the sensitivity (1-4).
Dimmer
Press 0-9 then press % button to adjust the dimmer.
Manual Color Control
1. Press MANUAL then press R, G, B, A to set the user’s colors on the controller.
2. You can press + or – to adjust the R, G, B, A colors.
Numbers buttons
3. Press any number between 0-9 to choose your color.
0=C15, 1=C1, 2=C4, 3=C7, 4=C2, 5=C5, 6=C3, 7=C6, 8=C9, 9=C4
Miscellaneous Operation
To black out the lights:
• Press BLACK OUT on the controller.
• This will turn off all the lights until the button is pressed again.
NOTE - The controller will not respond to any inputs when Black Out is activated. If the remote does not
respond when a button is pressed, try pressing BLACK OUT. You may have inadvertently activated BLACK
OUT.