PROLIGHTS - EclSoft
LinearIP
79
BALL HEAD JOINT (CODE EPTWCBHEAD - OPTIONAL)
1
2
B
A
C
C
A
B
3
1.
To mount the accessory, loosen the two M8 threaded screws (A) and remove the lower reinforced
plate (B) of the center mount bracket.
2.
Then screw the M10 threaded screw (A) with the threaded hole of the base of the ball head joint
accessory. Therefore reassemble the lower reinforced plate (B) and tighten the two screws (C).
Note: Insert the anti-rotation pins into the specific holes on the top lower reinforced plate of the
center mount bracket..
3. Then mount the short bracket (see previous page).
Note: To remove the accessory, the reverse operation.
Fig. 10