11
ECLIPSEJZIP
3.9 ADVANCED
You can change the parameters for the device by following these steps:
• Press on MODE to enter the menu mode.
• Press on UP/DOWN to select
Advanced
. Press the button ENTER to confirm.
• Press on UP/DOWN to select the desired option and press on ENTER to confirm:
-
Dimmer Mode
- Adjusting the dimmer. Enter in
Dimmer Mode
to select specific dimming curve.
Particularly when set:
•
Off:
The increase in light intensity is linear.
•
Dimmer 1:
dimmer curve with low fade.
•
Dimmer 2:
dimmer curve with medium fade.
•
Dimmer 3:
dimmer curve with high fade.
-
LED Frequency
- To adjust the frequency of the LEDs. Select the frequency
600 Hz - 25 KHz
using the UP/
DOWN and press on ENTER to confirm the selection.
-
Fan Mode
- Fan speed. Select the desired fan speed
Auto, On, Silent,
through UP/ DOWN.
-
Factory Reload
- To reset the unit. Select
Yes
or
No
and select ENTER to confirm.
• Press repeatedly on MODE to return the menu mode.
3.10 INFORMATION
To view all the information on the device, proceed as follows:
• Press on MODE to access the main menu. Press on UP/DOWN to select
Information
, then press on ENTER
to access the next menu.
• Press on UP/DOWN to scroll through the menu, then select one of the following information and press
on ENTER to display it.- Fixture Time - Through the Fixture Time function, the operating time of the
projector can be shown on the display.
-
Fixture Time
- To view the operating time of the projector.
-
Software Version
- To view the firmware version will show on the display.
-
UID
- To view the identification ID for the RDM control.
• Press repeatedly on MODE to return the menu mode.
3.11 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Press on MODE button so many times until the display shows
Stand Alone
, then press on ENTER.
• Select
Master/Slave
, then press ENTER.
• Using UP/DOWN, select the desired mode and then press ENTER.
• Press on MODE to go back or to meet the waiting time to exit the setup menu
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 15).
• Set the slaves to the same DMX modes.
NOTE: the unit, set in Static or Effect mode, always appears to be Master.
3.12 EFFECTS MODE
This fixture has a built-in automatic program. To access this, please see the below instructions:
• To enter the
Effects
mode, press MODE to access the menu, using UP/DOWN select
Stand Alone
, then
press ENTER to confirm.
• Use UP/DOWN to select the desired program
Effect 1
,
Effect 2
,
Effect 3
,
Effect 4
, then press ENTER to confirm.
• Set the value (
1 - 100
), through UP/DOWN, then press ENTER to confirm.
