11
CROMOBEAM250
(2)
MENU
Step
(001-255)
Tilt
(000-255)
Pan
(000-255)
Speed
(000-255)
Color
(000-255)
Gobo1
(000-255)
Gobo1 Rot
(000-255)
Dimmer
(000-255)
Strobe
(000-255)
Time
(000-255)
Use
No
Yes
Edit
Default
No
Yes
Default
3.4 OPERATION IN STAND-ALONE MODE
If no DMX control signal is present at the jack DMX INPUT (3), and the unit independently runs through its
show programme.
• Press the MENU button and select, via the directional buttons, the [
Intro
] menu choice, then press the
ENTER button to confirm the choice.
• Press the UP and DOWN buttons to select [
Run
] menu voice and confirm the choice by pressing the
ENTER button.
• Select a stand-alone operation mode: [
Auto1
], [
Auto2
], [
Sound1
], [
Sound2
], [
Custom
] or [
Test
], and press ENTER
button.
NOTE
. When the fixture is on Stand-Alone mode, it will be automatic set as master fixture.
3.5 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the MENU button and select, via the directional buttons, the [
Intro
] menu choice, then press the
ENTER button to confirm the choice.
• Press the UP and DOWN buttons to select [
Run
] menu voice and confirm the choice by pressing the
ENTER button.
• Select [
Slave
] to configure the slave fixtures.
• Select the desired operation mode (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
Summary of Contents for CROMOBEAM250
