ProLights BB5PIX, User Manual

Page: 27 / 40

9
BB5PIX
3.5 SOUND ACTIVE
• Press the button MENU so many times until the display shows [ ShMd ].
• Press ENTER to confirm
• Press the button UP/DOWN to switch between the programs ( Sh0 - Sh12 ), then press the button ENTER.
• You can set the microphone sensitivity pressing the button MENU so many times until the display show
[
Sen
]
• Using the button UP/DOWN, select the desired value sensitivity (slow-fast) [0-100] .
• Press the button ENTER to confirm.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows [SLMd] , and press the button ENTER to
confirm.
• Press UP/DOWN to set the unit as
[SL1-2]
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).
3.7 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3 -pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.8 DMX CONFIGURATION
BB5PIX is equipped with 2 DMX configuration.
• Press the button MENU so many times until shows [CHMd] , and press the button ENTER to confirm.
• Select the desired DMX configuration [4Ch - 5C] through the buttons UP/DOWN.
The tables on page 12 indicate the operating mode and DMX value. The BB5PIX is equipped with 3 pole
XLR connections.
3.9 DMX MODE
• Press the button MENU so many times until the display shows [ Addr ], and press the button ENTER to
confirm.
• Press the buttons UP and DOWN to select the desired value
[001-512]
.
• After the setting value is automatically saved.
NOTE - When fixtures are under Auto program operation, the [ Addr ] mode does no works.