ARCLED7361ZOOM
10
3.4 OPERATION IN AUTOMATIC MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
•
Press the button MENU so many times until the display shows [AUTO], then press the button ENTER.
•
Press the button UP and DOWN to switch between the programs (
AT.01 - AT.10 or PR.01 - PR.10
). The unit
will operate in automatic mode.
IMPORTANT: Programs
AT.01 - AT.10
are fully pre-programmed and will not be altered by changes in EDIT
mode. Programs
PR.01 - PR.10
are fully pre-programmed and can be edited in EDIT mode.
NOTE - In automatic mode the unit will be set as Master.
3.5 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
•
Press the button MENU so many times until the display shows
[RUN]
.
•
Press UP and DOWN to set the unit as slave
[SLAVE]
.
•
Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 12).
3.6 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.7 DMX CONFIGURATION
ARCLED7361ZOOM is equipped with different DMX configuration.
•
Press the button MENU so many times until shows
[PERS]
, and press the button ENTER to confirm.
•
Select the desired DMX configuration (
TOUR - ARC.1 - AR1.D - ARC.2 - AR2.D - AR2.S - HSV - HSVZ
) through the
buttons UP and DOWN.
The tables on page 13 indicate the operating mode and DMX value. The ARCLED7361ZOOM is equipped
with 3-pole XLR connections.
3.8 DMX MODE
•
Press the button MENU so many times until the display shows
[DMX]
.
•
Press the buttons UP and DOWN to select the desired value (
001-512
).
•
After the setting value is automatically saved.
3.9 DMX CONTROL
To able to operate the ARCLED7361ZOOM with a light controller, adjust the DMX start address for the first
a DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the ARCLED7361ZOOM. The other functions of the light effect
panel are then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
Summary of Contents for ARCLED7361ZOOM
