APIX6T
7
2. INSTALLATION REQUIREMENTS
This chapter specifies the requirements for safety, mechanism, electricity and control software of APIX6T
LED display.
Warning: This LED indoor product is designed for outdoor. Both outdoor and indoor can be used.
2.1 Mechanical Requirements
Weight Warning:
Do not underestimate the weight of a complete APIX6T LED display. Be sure that The
floor or truss installation on which the APIX6T display has to be installed is capable of Handling five (5)
times the complete load of the display. For floor mounting, conclude the weight of any other load.
Caution:
One APIX6T tile weighs approximately 13.5 kg.
Horizontal surface
For floor installation, the floor on which APIX6T display is installed must be horizontal. Never install LED
display on a slant surface.
Ballast
Depending on the height of the display and the position of the LED display upon the foot beams (some-
where between front and middle) additional weight (ballast)will be required.
Truss beam
The truss beam has to be provided and installed by the customer. Pay attention to following points for
installation design and preparation. Calculate precisely for on individual basis.
Weight tolerances:
Ensure that the truss beam and the ceiling against which the truss beam has to be installed is able to han-
dle the complete weight of the APIX6T LED display.
Ceiling stability.
Installation ambience
Environmental conditions: humidity, ventilation, temperature, etc.
Location: Altitude, etc.
Front clearances: for optimal effect, ensure that enough free space is supplied in front of the LED display
and respect the minimum viewing distance.
Comply with local regulations regarding such installations.
Warning:
Suspending installation is limited to 15 tiles in vertical direction.
2.2 Electrical Requirements
Power requirements
The displaying area of one APIX6T tile is 0.460 m². APIX6T LED tiles have pixel densities (see Appendix A –
technical specifications). For different pixel densities, one APIX6T tile may need power supply of 0.6 amps
to 1.5 amps at 220 VAC, 100-250 VAC, 50-60 Hz. Each APIX6T tile has one input and one output socket of AC
power. The power is distributed to display tiles by power split cables from power distributor. However, one
power split cable can be connected with 8 – 20 tiles in parallel. So, one power split cable has to be provid-
ed for every 8 – 20 tiles. Protect every power cable by a circuit breaker or fuses rated 16 A / 250 VAC (15 A /
110 VAC in the USA and Canada). PROLIGHTS provides a range of power distributor to satisfy the demands
of your LED display. See more details for power distributor of LED display in Power Distribution Section.
Contact PROLIGHTS for more information.
Summary of Contents for AlphaPIX6T
Page 1: ...ASSEMBLY INSTRUCTIONS APIX6T EN...
Page 18: ...APIX6T 16 3 Install all the tiles for a whole screen...
Page 25: ...23 APIX6T...
