Prolights Tribe JETSPOT-3, User Manual, Page: 40 / 52

JETSPOT- 3 14
for “Remote Device Management” and makes remote control of devices connected to the DMX-bus possible.
Manual settings like adjusting the DMX starting address are no longer needed. RDM is integrated in DMX
without influencing the connections. The RDM-data is transmitted via the standard XLR-poles 1 and 2 so new
DMX-cables are not necessary. RDM ready and conventional DMX devices can be operated in one DMX line.
If DMX splitters are used and RDM control is to be used, these splitters must support RDM.
3.12 OPERATIONS IN AUTOMATIC MODE
The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Stand Alone icon, then press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select Play and press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Sequence
and press ENTER to confirm
your choice.
• Press the UP/DOWN button to select the mode of operation:
- Master , if the unit is connected in series with other units and it acts as the Master;
- Slave , if the unit is connected in series with other units and it acts as the Slave;
• Press the ENTER button to confirm your choice.
• Press the MENU button repeatedly to exit the menu and save changes.
The unit will go into automatic mode by executing the program automatically.
3.13 AUTOMATIC MODE SPEED
Select this function to set the value of the speed of the internal auto-shows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Stand Alone icon, then press the ENTER button
to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, select
Play
, and press the ENTER button to enter
the next menu.
• Press the UP/DOWN button to scroll through the menu, then select Speed. and press ENTER to confirm.
• Press the UP/DOWN button to adjust the speed, and then press the ENTER button to confirm your
choice.
• Press the MENU button repeatedly to exit the menu and save changes.