Ages 6+
# 52703
For Customer Service
Send all correspondence to:
email: [email protected]
NSI International Inc.,
30 W 22nd Street, 3rd Floor, New York, NY 10010
Attn: Quality Control Department
Telephone: 888-425-9113
FCC
:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or
relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or experienced radio/TV technician for help.
BATTERY SAFETY INFORMATION
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the ProjeX Projector before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the ProjeX Projector.
•The supply terminals are not to be short-circuited.
• Keep packaging for reference since it contains important information.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Image Slide Storage
Display
Slide to Reload
ProjeX Blaster (2)
Trigger
Pointer (Not a real Laser)
Image Slide
Target Focus
Image Slide Storage
Blaster Storage
Battery Cover
(on bottom)
Blaster
Storage
Blaster Storage
Blaster Storage
Blaster Port
Power/Game Button (Red)
Blaster Port
Level Button (Blue)
© 2019 NSI International
Printed in China
SET UP INSTRUCTIONS – READ THIS FIRST!
Requires 3
AA (1.5V) Batteries (not included)
Does not use Laser. Beams are not visible. Simulated “Laser” pointer is LED. Do not point blaster at eyes.
