13
MOUNTING INSTRUCTIONS
INTELLI-CHARGE Chargers are designed for indoor, out of weather use only. Ensure that
both charger and battery are in a well-ventilated space during charging.
The battery charger end plates include a mounting flange for easy mounting. If
permanently fixed the charger should be mounted to a suitable horizontal or vertical
panel, with at least 10cm clearance from the end plates to provide adequate ventilation
for the cooling fan.
LITHIUM
GEL
AGM
WET
CALCIUM
PWR SUPPLY
1A
2A
4A
7A
IC7
12V 7A 7-STAGE
CHARGE
RATE
MODE
POWER ON
CHARGING
FULLY
CHARGED
3.5mm
mounting hole
PERMANENT WIRING TO BATTERY
It is possible to hard wire the DC charging leads to the battery for permanent installations.
You will need 2 x ring terminals, an inline fuse holder and a fuse with a rating equal
to or greater than twice the chargers output. (See below)
IC7 = use supplied wiring harness (15 Amp fuse)
IC7W = 15 Amp fuse
IC10 = 20 Amp fuse
IC15 = 30 Amp fuse
