9
RAPID CHARGE
Turn the ‘CHARGE RATE’ dial on the top panel of the unit to ‘RAPID CHARGE’ & set the
timer between 0-60min. The Rapid Charge function will provide a 70A charge to your
battery ideal for when a short powerful charge is required.
STEP 6 – CHARGING
During charging, the Charge Meter’s needle will decrease
towards the left. A fully charged battery is indicated by a very
low reading according to the battery’s capacity and condition.
Once this point has been reached, proceed to disconnect the
battery (Refer STEP 7 “DISCONNECTION”).
Important:
Charging will continue until the On/Off switch is turned to OFF.
The battery and charger must be monitored to ensure the battery is not overcharged.
Once charged, the liquid inside the battery may start to boil. It is recommended to stop
charging when this occurs to prevent damage to the battery.
STEP 7 – DISCONNECTION
Turn the ‘CHARGE RATE’ dial to the ‘OFF’ position and disconnect charger from
the 240V supply.
Battery out of vehicle
Remove the BLACK lead (battery clip) from the battery. Remove the RED lead (battery
clip) from the battery.
Battery in vehicle
Remove the chassis connection. Remove the battery terminal connection.
Charge Meter
HDBC90 Instruction Manual.indd 9
4/06/12 3:02 PM
