Projecta Charge N' Maintain Instruction Manual Download Page 3

3

4-STAGE AUTOMATIC CHARGING

  The AC008 & AC015 are fully automatic battery chargers with 4 charge stages.
  Automatic charging protects your battery from being overcharged so you can leave the 

charger connected to the battery indefinitely.

  4-stage charging is a sophisticated charging technique that gives your battery longer life and 

better performance compared to using traditional chargers.

  Projecta’s Charge N’ Maintain Battery Chargers are suitable for most 12V automotive, 

marine and Lithium batteries.

  The 4 charge stages are: 

Battery Health Check, Bulk, Absorption and Float.

BATTERY HEALTH CHECK,

  Checks to make sure the battery can accept charge.

BULK (CONSTANT CURRENT)

  The Bulk stage reduces charging time by charging the battery at the maximum rate (constant 

current) to a set voltage, at which point the battery is approximately 80% charged.

ABSORPTION (CONSTANT VOLTAGE)

  The absorption stage charges the battery to 100% by adjusting the charge rate allowing  

the battery to absorb more power.

FLOAT

  The Float stage maintains the battery at 100% charge without overcharging or damaging 

the battery. This means the charger can be left connected to the battery indefinitely.

FEATURES

SWITCHMODE TECHNOLOGY

  Using the latest technology in battery chargers, switchmode chargers convert 240V AC 

power to 12V DC power using electronic components unlike traditional battery chargers that 
rely on heavy transformers. This allows the charger to be lightweight and compact without 
sacrificing on performance.

SPARK-FREE AND POLARITY PROTECTED

  All Projecta Charge ‘N’ Maintain battery chargers are spark-free and are protected against 

accidental reverse connection making them safer to use around batteries.

WEATHER PROOF IP65

  The chargers are IP65 rated which means they can be used outside without getting 

damaged. Although the charger is a 240VAC device care should be taken that the plug  
is not submersed in water.

LED CHARGE INDICATOR

  The LED Charge Indicator is bi-colour and is green when charging and fully charged and 

yellow if there is a fault.

Summary of Contents for Charge N' Maintain









Reviews: