Progressive Turf Equipment TDR-22, Operator'S Manual And Parts List

Page: 40 / 96

TDR-30
Operator’s Manual
38
Operators must check the operation of the Pro Lift-N-
Turn™ system
prior to the start of each shift. Ensure that each latch plate (3 total) is in
the fully lowered (flat) position and the outer wing cylinder stops (2) are
in place before starting to mow.
If the Pro Lift-N-
Turn™ system is actuated with the PTO running,
and any of the latch plates are not in the correct position, the Pro
Lift-N-
Turn™ system cannot prevent that deck from rising too far.
Damage to the PTO drive will result. It is the responsibility of the
Operator to ensure the Pro Lift-N-
Turn™ system is functioning
properly before use.
TRANSPORTING THE MOWER
When transporting the TDR-30 from site to site, ensure the wings are in
the raised position and deck safety locks are engaged (Page 33).
Ensure the transport safety chain is properly fastened to the tractor
(Page 29).
Ensure SMV placard is clean and all loose debris has been removed
from the mower before transporting.
Observe the maximum allowable transport speed dependent on towing
vehicle weight:
Towing Vehicle Weight
Maximum Allowable
Road Speed
7400lb / 3357kg or more up to 20 mph (32 km/h)
3700-7399lb / 1678
– 3356kg
up to 10 mph (16 km/h)
Use an appropriate sized vehicle to tow the TDR-30 mower. Do not
tow with vehicles that are less than 3700lb / 1678kg, vehicle
handling and braking characteristics will be diminished.
Cylinder Stop Engaged
for mowing
Lock plate flat on wing plate
Lock Pin in
Storage Position