6.
Installing Fan to
the Electrical Box
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting bracket
as shown in Figure 11.
2. Install the ceiling mounting bracket on the
electrical box by using the mounting screws
provided with the electrical box. Note that
the flat side of the mounting bracket is
toward the electrical box. (Figure 11)
3. Tighten the two screws on the electrical box
securely.
4. Carefully lift the fan assembly up to the
ceiling mounting bracket. Make sure the tab
on the mounting bracket is properly seated
in the groove in the hanger ball. (Figure 12)
Figure 11
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
Figure 13
Installing the
Receiver into the
Mounting Bracket
1. Position the house supply wires to one
side of the slide-on mounting bracket;
position the fan wires to the opposite
side.
2. Insert the narrow end of the receiver (as
shown, flat side toward ceiling) into the
slide-on mounting bracket until it rests
on top of the ball/downrod assembly.
(Figure 13)
Figure 12
Standard mounting
Summary of Contents for AirPro P250071
Page 1: ...P250071 93153460_A...