REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual TEKNA TILT 2.0 5
SERVICE MANUAL
ANTI-TIPPER
Min. 1 cm, Max. 4 cm
To lower
the anti-tipper, screw off the bolt/washer/nut
A
and fix the tube one position lower.
The original assembly do not allow to lower the the tube more than one position (1.5 cm).
The fixing hole is usually the second starting from top.
If one position lower is not enough to make the system efficient, you need to replace the tube with a longer one.
To raise
the anti-tipper, screw off the bolt/washer/nut
A
and remove the tube.
Cut off 15 mm per position .
Insert the tube into the steel support and fix it with the bolt/washer/nut
A
When you change the seat height, it is necessary to check the efficiency of the anti-tip system and possibly re-adapt it to the new
height.
The anti-tip wheel should be al least 1 cm, but not over 4 cm from the ground.
Always try the efficiency of the anti-tip system before using the wheelchair.
A
Cutting lines