progeo NOIR 2.0, Service Manual

Page: 8 / 14

REHATEAM s.r.l.—vicolo Negrelli 5 — 31040 Castagnole di Paese TV - www.rehateamprogeo.com
Service Manual NOIR 2.0 8
SERVICE MANUAL
FOOTPLATE DISTANCE
The particular characteristic of this MODEL is the 7° front frame taper.
As it is visible from the picture, the longer the footplate distance DP , the
narrower the room X between the two frames at footplate’s level.
According to that, when adjusting the footplate distance, it is necessary to
keep the 7° taper and increase or decrease the room
X .
After adjustment, the forks have to be perpendicular to the ground. That will
tell you keep the 7° frame taper.
All footplates available for this model allows for such adjustment.
HEIGHT ADJUSTMENT EVERY 1.5cm
Usually, it is granted an adjustment of +1.5 cm and - 1.5 cm with respect to
the footplate distance requested.
Screw off the bolt A of both side of the frame.
Slide the tubes to the necessary height.
Make sure the height of the two sides is the same.
Insert the bolt A paying attention to fitting it with no effort into the threaded
hole B on the rear side of the support C .
The footplate tube’s holes and the hole of the support B must be aligned.
Finally, tighten the bolt A on both sides of the frame.
Do not force screwing the bolt, you may damage the thread of the hole B .
Should that occur, you can remedy by pass the threaded hole with a M5 tap
starting from the rear side of the support. If the thread is too damaged to be
repaired, you can pass the hole with a 5 mm drill bit and fix the tube with a
longer bolt, washer and nut.
You can not change the support C .
After adjustment, check that between the lower side of the footplate and the
ground there is at least 2 cm and that there is no interference between foot-
plate and casters.
90°
X1
X2
X3
DP
2.5° 2.5°
C
B
FRONT REAR
(A)
C
C
A
A