12
DO NOT MIX OLD AND NEW BATTERIES! DO NOT MIX
ALKALINE, STANDARD (CARBON-ZINC) OR
RECHARGEABLE (NICKEL-CADMIUM) BATTERIES!
TURNING THE HEATER ON
To turn the heater ON, press the ON/OFF rock switch to ON
position, the power LED will turn on and display the room
temperature.
The factory setting temperature is 70
℉
, If you set the
thermostat switch to Inside Thermostat, and the room
temperature is lower or equal to 68
℉
, the heater will turn to
High mode and will turn off when the room temperature is
higher or equal to 72
℉
.
SETTING THE TEMPERATURE
To set the desired temperature:
Press the
Thermostat
button, and then press the
+
button to
increase the temperature or the
-
button to decrease the
temperature.
You can also press the
+
button until the numeric temperature
starts flashing. Press
+
button again to increase the
temperature or the
-
button to decrease the temperature.
After setting the desired temperature, the heater will run on
heating when the room temperature is equal to or lower than
the setting temperature - 2
℉
, and will turn off when the room
temperature is equal to or greater than the setting
temp2
℉
.
Note: If you set the thermostat switch to WALL THERMOSTAT,
press the + and - button cannot set the temperature, the heater
will run in ON or OFF heating according the wall thermostat
setting temperature.
