ProT
ungsten Air
15
www.profoto.com
Maintenance
Changing lamp
SAFETY PRECAUTION!
Do not touch lamp bulb with bare hands. Cleaning cloth is included with Profoto supplied bulb.
1. Ensure that the Power Cable [8] is not connected.
2. If the ProTungsten Air unit has been in use, wait for the unit to cool down.
3. Unlock the glass cover by lifting the safety pins one by one out from the top screw, see
figure on page 11.
4. Gently remove the glass cover.
5. Pull the lamp bulb straight out of the socket. Always use protective gloves when doing
this.
6. Insert a new lamp bulb, straight into the socket. Do not touch the bulb with bare hands.
7. Gently fit the glass cover in place.
8. Make sure that the circuit breaker is pressed down and that both safety pins fit properly
into the slots on each side of the glass cover, see figure on page 11.
9. Secure the glass cover by pressing the safety pins one by one under the top screw.
Changing fuse
There is one exchangeable fuse in the mains inlet on the Power Cable [8].
1. Disconnect the Power Cable [8] from mains power.
2. Pull out the fuse holder on the mains inlet and remove the old fuse.
3. Gently push the new fuse all the way into the fuse holder. Only use fuses specified in
section
Technical data.
4. Gently push the fuse holder in place.
