ProDaylight 800 Air
13
www.profoto.com
Reflector mounting
1. Unlock the clasp on the reflector.
2. Slide the reflector onto the ProDaylight 800 Air unit. Use the Zoom Scale [12] to place
the reflector in the desired position.
3. Secure the reflector by locking the clasp.
Power connection
1. Connect the Lamp Cable [8] to the Lamp Connector [B] on the ProBallast 800 by
aligning the white dots on the cable plug with the white dot on the ballast panel. Secure
by turning the ring on the plug clockwise.
2. Connect the AC mains cable to the Power Connector [E] on the ProBallast 800 and to
the mains power supply outlet.
3. Use the On/Off Switch [A] to turn on the ProBallast 800.
4. The Power Indicator [2b] on the ProDaylight 800 Air unit will be red, indicating that the
unit is receiving power but is in standby mode.
5. Press the On/Off Button [2a] on the ProDaylight 800 Air unit or the Start Button [C] on
the ProBallast 800to turn on the ProDaylight 800 Air unit.
6. The Power Indicator [2b] on the ProDaylight 800 Air unit will now be green.
Radio settings
1. Activate the built-in radio transceiver by pressing the Radio Button [3a] and verify that
the Radio Indicator [3b] is illuminated (green).
2. Press the Channel Set Button [5]. The Display [1] will start flashing, showing the current
radio channel number to the left and the radio group letter to the right.
3. While the Display [1] is flashing, turn the Setting Knob [6] clockwise to increase the
radio channel number (
1
to
8
) and counter-clockwise to decrease the number.
4. While the Display [1] is flashing, press and hold down and turn the Setting Knob [6]
clockwise to increase the group letter (
A
to
F
) and counter-clockwise to decrease the
letter.
5. Wait until the Display [1] stops flashing. (The Display [1] will now show the light
intensity.)