1
Switch on the remote control
Switch off after use
2
Check if M
ODE
is set to
Transmit
3
Check C
HANNEL
:
The highlighted number must correspond with the label on
the remote control and the flash heads
If not: push the C
HANNEL
button until the right number (1-6) is highlighted
4
Push the M
ASTER
button to select all Groups (flash heads)
5
Push the | button of the H
EAD
section to activate the flash heads
Push the 0 button after use
6
Use the buttons of the M
ODEL
section to switch the modelling lights on or off
7
Use the T
EST
button to check if the flash is responding
8
Set the flash value for all light heads with the E
NERGY
+ and - buttons
Short push for small increments, long push for large increments
9
Set G
ROUP
to A or B to change the flash value for individual light heads with the E
NERGY
buttons
or to switch individual light heads on or off with the H
EAD
buttons
Mandatory settings in red
