Big Studio Quick Start Guide
1
Turn on the flash head
(you can also use the H
EAD
button on the remote control)
Turn off after use
2
Check Channel and Group (only when using Profoto remote control):
The number and letter in the display must correspond with the ones on the label
If not: turn the setting knob (7) to set the channel (numbers 1 to 6)
push and turn the setting knob to set the group (A or b)
3
Set Modelling light to
PROP
(proportional)
4
Set Ready indicator to
BEEP
5
Set the Slave function:
RADIO:
the flash will respond to the Profoto Remote Control
IR : the flash will be triggered by another flash or an IR remote control
6
Do not change this setting
The value should always be
10
7
Use the Setting knob to adjust the flash value:
Turn for small increments
Push and turn for large increments
Mandatory settings in red
,
Recommended settings in blue
Most of our flash heads are hanging on the ceiling, so this is how you will see their displays: upside down
