ProHead
7
www.profoto.com
Connecting Lamp Head
When connecting the lamp head plug to the lamp head socket, align the dots on the plug with the white dot
on the generator panel. Push the plug all the way in. Secure by turning the locking ring on the plug clockwise.
Changing Fuse
The fuse is placed at the back of the head. Unscrew the fuse holder counterclockwise. Pull
the fuse out. Use fuses that are recommended, for more details please read “Technical Data”.
Push the new fuse all the way in. To lock the fuse holder after the fuse is changed, screw the
fuse holder clockwise.
Changing Glass Cover
When removing the glass cover, unlock the two safety pins by pressing down and pulling, one by one.
Remove the glass cover. To lock the glass cover when the glass cover or lamps are changed, fit the glass
cover carefully and make sure the safety pins fit properly in the existing holes on each side of the glass
cover. Secure the glass cover to lock by pressing the safety pins down and then pushing them one by
one under the top screw.
1: Press down the safety
pin to release
2: Pull the safety
pin out
CHANGING GLASS COVER
Unlock glass cover
Do not touch hot parts with bare fingers! Modeling lamps, flash
tubes and certain metal parts emit strong heat when used!
When changing modeling lamp, flash tube, fuse or glass cover
the lamp cable must be disconnected from the generator.
3: Press down the safety
pin and fit under the screw
to lock
CHANGING GLASS COVER
Lock glass cover
2: Push the safety pin in
1: Fit the safety pins in
existing holes located
on the glass cover
3.15 AT
Fuse
