9
5. Remove the two warning decals (not shown) from
the spa shell. Using a damp cloth, wipe the spa
shell clean. Before filling the spa, make sure that
it is in the desired position and that there is
room to service the spa. Once the spa is filled, it
will have to be drained before it can be moved.
Insert a garden hose into the filter housing, and
begin filling the spa. Do not use soft water. The
spa may be filled with cold water; however, if warm
or hot water is used, the spa will be ready for use
sooner. Fill the spa until the water is at the level of
the molded fill line. Do not overfill the spa.
Refer to the inset drawing. Set the Filter (16), the
Cartridge Plug (49), the Diverter Plate (33), and the
Basket (43) into the filter housing. Next, screw the
Filter Cover (8) into the filter housing until it is fully
seated.
4. The spa operates on a 240 volt power source and must be wired directly to a 30 amp Ground Fault Circuit
Interrupter (GFCI) installed in your home. This procedure must be performed by a qualified, licensed
electrician. A wiring diagram has been provided on the inside of the electronics package as a reference.
Under no circumstances should the spa be wired by someone other than a qualified electrician. Before
you have the spa wired, make sure that it is in the desired position and that it can be serviced, if needed.
6. Pull down one of the straps on the Spa Cover (11)
and hold the Buckle (30) against one of the cedar
panels on the spa. (Note: To position the Buckle cor-
rectly, have a second person hold the strap on the
opposite side of the Spa Cover tight.) The Spa
Cover must be tight. Do not place the Buckle
over the grooves between the cedar panels. Refer
to the inset drawing. Remove the latch from the
Buckle. Attach the Buckle to the cedar panel with two
#4 x 3/4” Screws (31).
Attach the other three Buckles (30) to the cedar pan-
els in the same way.
Remove the Spa Cover (11) from the spa.
5
Garden
Hose
Filter
Housing
6
11
30
Strap
Strap
Latch
30
31
8
43
16
3. Locate the three pillows. Each pillow can be
attached to the spa shell in a high position or a low
position. To determine the high and low positions,
attach one pillow to the spa shell, note its position,
remove it, turn it 180°, and then re-attach it. Attach
the three pillows in the desired positions.
3
Pillow
Pillow
Pillow
33
49
Filter
Housing
