Refer to the console diagram above. The function of
each console control is explained below:
Temperature:
Controls the temperature of the water.
The water heats at about 2.0¡F an hour with the cover
on. The thermostat can be set to heat the water from
70¡F to 104¡F. Always use an accurate thermometer
to check the temperature of the water.
Pump Control:
Turns the thera-jets
on and off. To turn the thera-jets on,
press the control once. To turn
the thera-jets off, press the control
again. The thera-jets will remain off
for 20 minutes. After 20 minutes, the
pump will begin cycling to heat the
water if the temperature falls below
the minimum setting.
Note: To keep
the heat cycle from running, the
power cord must be unplugged.
Air Control:
Determines the amount
of air that is in the spa jet system during operation. If
the control is turned to the left, the amount of air flow-
ing through the jets will increase. If the control is
turned to the right, the amount will decrease.
Refer to the diagram above. The function of each spa
jet is explained below:
The
three uni-directional thera-jets
(A), located on
one end of the spa, focus the water massage on your
back.
The
three multi-directional thera-jets
(B) can be
adjusted for a custom hydro-massage. One of the jets
is located below the three uni-directional thera-jets
and focuses the water massage on your lower back.
Another jet, located near the floor, focuses the water
massage on your legs. The remaining jet, located on
the other end of the spa, focuses the water massage
on your upper or lower back.
The
filter
(C) can be removed for replacement and
cleaning (see CHECKING AND CLEANING THE FIL-
TER on page 13 for information on how to remove the
filter from the spa).
.
The
suction vents
(D), located near the floor of the
spa, bring the water into the pump, in order to operate
the system. The suction covers should always be in
place over the suction vents.
Never operate the spa
without the suction covers in place.
This spa is ozone ready. An optional ozone generator
can be installed to utilize the
ozone jet
(E). Ozone
provides a way to help sanitize your spa with minimal
chemical treatment.
The RESTORATION 2.0 features automatic freeze
protection. If the water temperature falls below 40¡F,
the pump will begin circulating and heating the water
to prevent the water from freezing.
A
B
B
C
E
D
SPA JET OPERATION
11
USING THE CONSOLE
