9
4.
Before you fill the RESTORATION 600, be sure that
it is in the position you want, and that it can be eas-
ily serviced, if needed. Once the RESTORATION
600 is filled with water, it will need to be drained to
be moved.
Using a garden hose or other clean water source,
begin filling the RESTORATION 600, until the jet
and filter openings on the Spa Jet Unit (13) are cov-
ered with water.
Do not fill the RESTORATION
600 more than 20Ó deep with water.
After the RESTORATION 600 is full, you must
prime the Spa Jet Unit (13) before using the
RESTORATION 600 (see PRIMING THE SPA JET
UNIT on page 10).
5.
Insert the Support Ball (4) into the mesh pocket on
the underside of the Spa Cover (11).
See inset drawing A. Insert the inflation tube into
the hole in the Support Ball (4). Inflate the Support
Ball.
See inset drawing B. When the Support Ball (4) is
inflated, remove the inflation tube from the Support
Ball and insert the ball plug through the mesh into
the Support Ball.
The head of the ball plug will
hold the Support Ball in place.
Note: The Support Ball (4) is not a toy.
6.
Place the Spa Cover (11) over the Fabric Spa
Surround (8), the Inflatable Spa Liner (9), and the
Spa Jet Unit (13).
Be sure that the Spa Cover is
properly centered and that the straps on the
Spa Cover line up with the straps on the Fabric
Spa Surround.
Snap each of the six latches on the Spa Cover (11)
into the buckles on the straps on the Fabric Spa
Surround (8).
6
4
9
13
8
11
13
Latches and Buckles
B
A
11
Mesh Pocket
4
4
Inflation
Tube
Ball
Plug
4
5
