3. Insert the Wire Harness (53) into the right Upright
(37) as you press the Console Base (45) onto both
Uprights. Insert two Console Base Bolts (29) through
each side of the Console Base and through the
Uprights as shown. The Console Base Bolts must
be inserted from the inside as shown. Tighten a
Console Base Nut (11) and a Console Base Washer
(39) onto each Console Base Bolts. Note:Carefully
lift up and push down on the handrails to make
sure that the Console Base does not move.
Regularly inspect and tighten all four Console
Base Bolts and Console Base Nuts.
4. Attach the Frame Guide (66) and the Frame Guide
Spacer (46) to the left side of the Frame (21) with
four Latch Screws (25). Note: Be careful not to
overtighten the Latch Screws. Make sure that the
thick end of the Frame Guide is at the bottom.
5. The Console (49) requires two 1,5V batteries
(included); alkaline batteries are recommended.
Open the Battery Cover (48) as shown. Press two
batteries into the battery compartment, with the
negative ends of the batteries (marked “–”)
touching the springs. Close the Battery Cover.
5
4
11
6
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand
as shown. Using your left hand, slide open the storage
latch. Pivot the treadmill until the frame guide and the
foot rail are past the storage latch.
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. To decrease the possibility of
injury, bend your legs and keep your back straight.
Opened
Storage
Latch
Frame
Guide
21
48
49
Batteries
66
46
Thick end
25
6. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-
pet from damage, place a mat under the treadmill.
37
45
39
11
29
29
53
11
39
3
