14
USING THE CONSOLE
Refer to the console diagram above. The function of
each console control is explained below:
Temperature Display:
During normal use this display
shows the actual water temperature. When the Set
Temp indicator is lit, the display shows the set
temperature.
Light:
This button turns the light on and off. When the
light is on, the indicator above the light button will be
lit. The light will automatically turn off after two hours.
Pump:
This button turns the pump on and off. When
the pump is running, the LED indicator above the but-
ton will light. To turn the pump on high, press the but-
ton once. The thera-jets will operate at full speed. To
turn the pump on low, press the control twice. The
thera-jets will operate at low speed. After you press
the button a third time, the thera-jets will shut off,
unless it is time for the heat or filter cycles. If you turn
the pump off and it continues to operate, check if the
Heat On or Filter On indicators are lit to see if either
cycle is running.
Set Temp:
This indicator will light when the tempera-
ture is adjusted by using the up and down buttons. To
adjust the temperature, press either the up or down
buttons to select a new temperature. The thermostat
can be set to heat the water from 41¡F to 104¡F.
While you are setting the temperature, the tempera-
ture display will show the new temperature. The new
temperature will remain in the display for five seconds
after you release the buttons. Then the Set Temp light
will turn off and the display will return to the actual
water temperature. The water heats at 6.0 to 8.0¡F
per hour with the cover on.
Heat On:
This LED indicator is lit when the spa is run-
ning the heating cycle.
Filter On:
This LED indicator is lit when the spa is
running the filter cycle.
Note: To keep the heat and filter cycles from run-
ning, shut off the circuit breaker or GFCI.
Air Control:
Determines the amount of air that is in
the spa jet system during operation. If the control is
turned to the left, the amount of air flowing through
the jets will increase. If the control is turned to the
right, the amount will decrease.
Error Messages:
When certain problems occur, the
Temperature Display will show an error code. The
error codes are explained below:
HL
High temperature protection mode. If the water
temperature rises above 115¡F, the heater will
shut off. If the temperature rises above 122¡F,
the high temperature circuit will shut off the
entire system. In either case, once the water
has cooled to normal, you can press any button
to reset the system.
FrE
Freeze protection mode. If the water tempera-
ture falls below 40¡F, the pump will begin
cycling the water through the heater to raise the
temperature. This cycle will run for one minute
and may be repeated as needed.
FLC
Flow related problems. You will need to call our
customer service department.
FLO
Flow related problems. You will need to call our
customer service department.
PrH
High temperature probe problem. You will need
to call our customer service department.
Prr
Temperature probe problem. You will need to
call our customer service department.
CONSOLE DIAGRAM
