Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap.
IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest setting, the
drive belt may need to be adjusted. To adjust the drive
belt, see assembly step 11 on page 11 and remove
the Left Pedal Leg (24) and the Left Link Arm (25).
Then, see EXPLODED DRAWING A near the end of
this manual and remove the M6 x 25mm Button Screw
(61) from the center of the left Crank Arm Cover (32),
and then carefully remove the left Crank Arm Cover.
Next, remove all the screws from the left shield, and
then carefully remove the left shield.
Loosen, but do not
remove, the three
screws (A). Insert
the shaft of a
screwdriver down-
ward between the
Idler (12) and the
pulley located on
the Eddy
Mechanism (10).
Pull the top of the
screwdriver toward
the rear of the
elliptical exerciser until the Belt (84) is tight, and then
tighten the three screws.
Reattach the left shield and the left crank arm cover.
Then, see step 11 on page 11 and reattach the left
pedal leg and the left link arm.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first see EXPLODED DRAWING A near the
end of this manual and remove the M6 x 25mm Button
Screw (61) from the center of the right Crank Arm
Cover (32), and then carefully remove the right Crank
Arm Cover.
Next, remove all the screws from the left shield, and
then carefully remove the left shield.
See the drawing below and locate the Reed Switch
(21). Loosen, but do not remove, the indicated M4 x
16mm Screw (72). Slide the Reed Switch slightly closer
to or away from the Magnet (18) on the Pulley (13).
Then, retighten the M4 x 16mm Screw (72). Turn one
of the Crank Arms (31) for a moment. Repeat until the
console displays correct feedback. When the Reed
Switch is correctly adjusted, replace the crank arm
cover.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 6 on page 8
for replacement instructions. If the console does not
display your heart rate when you hold the handgrip
pulse sensor, or if the displayed heart rate appears to
be too high or too low, see step 5 on page 15.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical exerciser rocks slightly on your floor
during use, see HOW TO LEVEL THE ELLIPTICAL
EXERCISER on page 12.
HOW TO GREASE THE ROLLERS
See the EXPLODED DRAWING near the end of this
manual. If the Rollers (27) squeak when moving on
the Track (2), apply the contents of the included pack-
et of white marine grease equally to each Roller.
Spread the grease evenly around the Rollers. Pedal
the elliptical exerciser until a thin film of grease is dis-
tributed along the Track; wipe off any excess grease.
22
MAINTENANCE AND TROUBLESHOOTING
21
18
13
72
31
10
A
12
84
