ProFlow PF-PHN, Installation & Operating Instructions Manual, Page: 9 / 53

ELECTRONIC CONTROL PANEL
Page 9
EN - English
1. Press the scroll  button repeatedly until the display
shows:
•
•
Press the up

or down

button to activate the
holiday mode by setting the number of full days away
from home , or deactivate the holiday mode (OFF).
Once the control panel is back in service mode, the display
will show:

The holiday mode is automatically cancelled when a
regeneration is manually initiated!
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS

Before entering the programming mode, make sure that
the appliance is in the service mode.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1.
Press the scroll  button and hold it for 2 sec until the
display shows:
•
Press the up  or down  button to set the
language .
2.
Press the scroll  button again; the display will show:
•
Press the up

or down

button to set the time of
day .
3. Press the scroll  button again; the display will show:
•
Press the up  or down  button to set the number
of days between regenerations .
4. Press the scroll

button again; the display will show:
•
Press the up  or down  button to enable or
disable the buzzer.
5. Press the scroll  button again; the display will show:
•
Press the up  or down  button to save the settings
into the NOVRAM® and exit the programming mode.

The regeneration cycle is necessary to prevent ‘caking’
of the filter media during the service cycle, which may result
in an increase of pressure drop over the appliance. Typically
a regeneration every 7 days should be sufficient. In case of
high flow rates, excessive water usage or a high
concentration of impurities in the incoming water, it may be
necessary to lower the number of days between
regenerations.
Holiday: OFF
8:01 Holiday
Set time: 8:01
Interval: 7 Days
Exit
Language: English
Buzzer: ON