Proficook PC-GG 1058, Instruction Manual

Page: 15 / 19

61
Switching on the side burner
You can operate the side burner separately.
1. Open the cover of the side burner before you ignite it.
2. Press the adjustable knob of the burner and turn it anticlockwise to the HI position. At the same time, you will hear a CLICK. The burner will ignite. If the
burner does not ignite, repeat this step.
3. If the burner still does not ignite, wait 5 minutes and repeat step 2.
4. If the burner does not ignite, ignite the burner with a long match. Contact your dealer or gas technician in order to resolve the fault with the ignition.
5. Regulate the heat by turning the adjustable knob to any setting of your choice between the HI and LOW setting.
6. In order to shut down the burner, turn the adjustment knob to the 12 o’clock position (OFF).
7. In order to shut down the entire barbecue, close the valve on the gas cylinder and turn all the adjustment knobs to the 12 o’clock position (OFF).
Head distribution on the grille
As a result of the design of burner, the heat distribution is specified as follows:
Barbecue cooking
Cooking
Keeping warm
Tips for barbecue cooking
The gas barbecue is a multifunctional appliance. With the hood closed, you can use your gas barbecue like an oven.
• You don’t have to only barbecue meat, fish, vegetables and fruit, you can also cook them.
• With a closed hood, the temperature should not be allowed to get too high. A low temperature results in gentle cooking of the barbecue food.
• Monitor the temperature on the thermometer and if necessary, adjust it.
• The following applies as a rule of thumb: If smoke emerges from a closed hood, the temperature is too high!
Troubleshooting
Malfunctions are often just caused due to minor problems. Before contacting our customer service, please check the table below:
Problem Possible cause Notes/solution
The burners cannot be ignited
by the ignition system.
1 Gas cylinder is empty
2. The regulator is damaged
3. The burner is blocked
4. The gas jets or hose is blocked
5. The electrode wiring is loose or separated from the elec-
trode or ignition
6. The electrode or cable is damaged, faulty switch ignition
1. Replace the gas cylinder
2. Check or replace the regulator
3. Clean the burner
4. Clean the jets and the hose
5. Reconnect the cable
6. Replace the electrode and the cable
Replace the ignition device
Burner does not ignite with a
lit match
1. Gas cylinder is empty
2. The regulator is damaged
3. The burner is blocked
4. The gas jets or hose is blocked
1. Replace the gas cylinder
2. Check or replace the regulator
3. Clean the burner
4. Clean the jets and the hose
No yellow flame or back cou-
pling (fire in the burner line –
hissing or bubbling noise)
1. Gas cylinder is too small
2. Burner blocked (insect nest?)
3. The gas jets or hose is blocked
4. Draft
1. Use a larger cylinder
2. Clean the burner
3. Clean the jets and the hose
4. Set the barbecue up in a protected location