Nortek Security & Control LLC
13
Using Auto EQ
Auto EQ is used to compensate for and correct for acoustic
room anomalies that can cause inferior bass performance .
Auto EQ takes a series of measurements in and around
your primary listening position, makes complex calculations
and applies those acoustic corrections- all from the comfort
of your listening area .
1.
To begin Auto EQ, make sure that the Auto EQ toggle is turned on,
then press the Start button.
2.
Choose up to 3 locations near your listening area and run each
sweep.
3.
Once finished select “calculate” to apply the Auto EQ room correction to the subwoofer.
4.
Repeat steps 1-3 for each additional subwoofer in the system.
Settings
1.
Audio Sense. Sets the approximate time it takes before the
subwoofer goes into Standby mode when no audio signal is
present. You can select between 5, 10, 20, 30 minutes or always
on
2.
Reset to Default. Puts the subwoofer back to its factory default
settings.
NOTE:
Before you begin, be sure to shut
off all sources of ambient noise before
taking measurements . Failure to do so
may cause undesired/sub-optimal effects .
